FS: Weber 48 IDA set-up for 12-A
#1
I have a complete Weber 48 IDA set-up for a 12-A for sale. It was purchased from Racing Beat for $900 and includes the carb, manifold, phenolic spacers, gaskets, throttle cable bell crank and K&N air filter assembly. The carb has been used for a total of 1 hour to get a motor running and stored since. I no longer need it as we went a different route on an engine conversion(F20C).
The carb is supplied with the following internals:
- 37mm venturis
- 2.0 needle valve
- 50 accelerator pump jet
- 70F10 idle jet holder
- 170 idle jet
- 120 ai corrector
- F7 emulsion tube
- 135 main jet
All you would need is a proper intake manifold gasket and the 2 coolant passage o-rings.
$575 shipped in the US. Please reply to dlipperini-at-adelphia.net as I do not frequent this forum.
Thanks,
Dan Lipperini Jr
www.twojacks.com
The carb is supplied with the following internals:
- 37mm venturis
- 2.0 needle valve
- 50 accelerator pump jet
- 70F10 idle jet holder
- 170 idle jet
- 120 ai corrector
- F7 emulsion tube
- 135 main jet
All you would need is a proper intake manifold gasket and the 2 coolant passage o-rings.
$575 shipped in the US. Please reply to dlipperini-at-adelphia.net as I do not frequent this forum.
Thanks,
Dan Lipperini Jr
www.twojacks.com
Thread
Thread Starter
Forum
Replies
Last Post
chrisw80
2nd Generation Specific
1
08-05-2007 11:58 AM
Latin270
RX-7 & RX-8 Parts For Sale & Wanted
4
05-02-2005 09:30 PM
toyotaownsyou
RX-7 & RX-8 Parts For Sale & Wanted
5
02-21-2005 09:11 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)