Pulling out and selling engine and 5 speed tranny. Engine has 16,200 miles since rebuild. All accesories included. (air pump not installed, but I will provide it separately). Engine has silicone vacuum lines, underdrive pulleys on alt. and water pump, 1200 cc injectors, Pettit lightweight flywheel with ACT clutch. Stock twins rebuilt with clipped secondary. Engine runs great, both turbos spool strong. No oil leaks. All hoses were replaced at time of overhaul. Transmission has 93,100 miles, all syncros good.



Engine is in Austin, Tx. Local buyer preferred, but will ship at additional cost.

Asking $3500



email: mikes94fd@yahoo.com

 

Price reduced: $3200

 

bump

 

Still for sale. Engine and Tranny out of car and ready for local pickup in Austin, Tx. Price negotiable, of course.

 

what else would be needed to drop this into a fc?

 

Good question. I would not be the one to give out expert advice on this, but what comes to mind is that the engine mounts are in different locations. The FD's mount through the oil pan, under the rear endplate. I am sure the mounting locations are there for your FC mounts, just a new oil pan may be required. I could be mistaken, though.

 

you would need engine mount adapters, and use the TII transmission. http://www.motivefab.com/ has adapters. and computer etc etc. basically it isnt a DIRECT drop in, but not to hard

 

I'm interested in a motor, how much for the block? Who did the rebuild? Any documentation to show proof of rebuild? Thanks Bryan