Fc Parts
03-06-2005, 09:35 AM
#11
Senior Member
Thread Starter
Join Date: Oct 2003
Location: Pittsburgh, PA
Posts: 334
Originally Posted by RX7ryder' date='Mar 4 2005, 04:34 AM
does the strut bar just go straight across? or does it bend like a "U"? if u have a pic that would be cool. thx
The bar pretty much goes straight across, there is a slight offset of about an inch or so. I do not have an installed pic, because I never installed mine. I will have to see if my friend still has a pic of his.
The Camber adjuster is the "on the car" type, so you do no thave to remove it. The DTSS bushings are my own, they are machine from Solid stainless steel. If you have ever seen the FEED or RE DTSS bushings they are the same as theirs,but Stainless rather than mild steel.
03-06-2005, 12:43 PM
#13
Senior Member
Thread Starter
Join Date: Oct 2003
Location: Pittsburgh, PA
Posts: 334
Sounds good, just toss me an email at sikokillr@aol.com or pm me. BTW the prices are shipped, if you buy them both I will knock off $5 since they would be shipped at the same time.
