NoPistons -Mazda Rx7 & Rx8 Rotary Forum - FC 13B-RE project part out!

Ok have huge list to put up will post some pics that show the parts but putting pics to each part would be huge!!! I you want the part pm me and I'll do my best to send you a pic of what you want to see..some of it is already off the car and can be sent out quickly. If I can I would like to sell these as a package and the prices will be pretty good.

Turbonetics T04E dual BB .57 p trim w/ custom 1.0 hotside w/ heat coating by Turblown.net (1Revvin7)

Turblown custom manifold w/ egt bungs in each runner, coated

Turbosmart Ext. wastegate V-band

Trublown 3.5inch Downpipe coated w/ o2 bung and egt bung.

PWR FMIC w/ mount for FC 24x3x12

$2600 for all that

Haltech e6k /w program all sensors and the extras that came with it.. 3bar map sensor, 4 wire o2

Nology coils

nology plug wires This set up is ready to go no need to splice into your existing coil wires

laptop if needed

$900

ACT extreme clutch

ACT extreme flywheel

new slave cyl w/ SS clutch line

$550

DEFI Gage setup w/ link unit II (boost, tach, oil temp, oil press, water temp, fuel press., EGT)

HKS turbo timer

$750

Sparco racing wheel w/ Works Bell quick release system

2 Sparco seats (black) with brackets 1 racing bucket, 1 rec.

$900

Tein coilovers w/ tein camber plates (front)

Adjustable rear camber links and bar from mazdatrix http://www.mazdatrix.com/h6_86-92.htm

$ 950 for everthing

T2 front and rear Calipers (new reman)w/ hawk pads

Front & rear power slot rotors

SS brake lines

$500

Fuel rails Pri and Sec of 13b-re KG parts w/-6 an fittings

x2 RC 550 inj x2 Bosche 1680 sec. inj.

SX Fuel press reg. w/ -6 fittings

Y fuel splitter w/ -6 fittings (Was running a parallel fuel setup)

$450

T2 rear Diff w/ Kazz 1.5 way lsd

$ 600

some other goodies too like body kit, core RE block, Blitz DD blowoff valve, EXt aeromotive fuel pump w/ 2 filters, Alum 10 gal fuel cell, T2 tranny, dual oil cooler setup SS lines oil filter relocation kit.