143hawaii

I've recently sold my Aquamist system since I was in need of money. I now have some extra parts that I had ordered in plans of adding. They can be used with both any Aquamist kit or a DIY water injection system.



Aquamist Water Pressure Gauge



It's a 40mm gauge that reads from both 0-160psi and 0-11bar. It has a chrome plated bezel and comes with panel mounting hardware similar to that of Autometer's. It also includes ~2 meters of nylon hose so that it's ready to be hooked up to your existing system. Also an additional quick type "T" push-in fitting is included so that you can tap your existing line. It's brand new but used once to test if it worked. Price is $40 shipped.









Aquamist 0.5mm Water Jet



I was planning on using this for a dual jet setup along with my 0.4mm jet below. It's never seen any water and is completely brand new. Price is $16 shipped.







Aquamist 0.4mm Water Jet



It's also completely brand new. Price is $16 shipped. Or if you purchase both 0.5mm and 0.4mm jets, it's $30 shipped.







3 Meters of Aquamist 4mm Nylon Hose



Brand new and never used. Price is $10 shipped.







Aquamist 4mm "Y" Quick Type Connector



Brand new and never used. Price is $5 shipped.







Aquamist Water Level Sensor (Float Switch)



Ideal for detecting the rise and fall of liquid and also to detect the presence of liquid. Consists of a reed switch and pivoted actuator magnet encapuslated in waterproof polymer mouldings (nylon 11). Can be used for 'normally open' or 'normally closed' operation, depending on orientation. External mounting for ease of installation (19mm or 3/4 inch hole required). Brand new and never used. Price is $35 shipped.







Aquamist Anti-Surge Accumulator



The accumulator does two jobs, it absorbs the peak pulses generated by the piston and stores it rather loosing it as back pressure seen by the forward moving piston. As a result, the capacity and the avarage pressure of the pump is increases between 10-12%. The second job minimizes the chances of the interrupted water delivery due to line surges generated by non-baffled water tank during occasional hard cornering manuvures.

It comes with two plastic clip on mounts. This is the only part that's been used here. It had been used with my previous Aquamist system for a couple of months. Price is $30 shipped.







Feel free to PM me or e-mail me at mitch@hawaii.rr.com with your interest or questions. Thank you.