13b bridgeport motor set. 3mm apex seal,se rotors, 58mm ida weber gene berg with port manifold, 2 msd coils, custom header, rb flywheel,act pressure plate,rb 4 puck disc, recently gone trough trans with mazda trix short shifter, new starter, schattersheild, cater fuel pump,fram gas filter,holley regulator,rb plug wires,duel pulleys. put down 200rwhp with old twin weber set puts more down now.. nearly turn key. fits into 1st gen rx-7. dlesky@cfl.rr.com for pics or more info...$3500 obo...

$2500 obo burning a little oil.......

$2250obo

http://www.floridadrift.com/forum/viewtopic.php?t=4516

link for picture.......

Where is this located?

I'm in central florida,Titusville ...orlando's beach front ......Dave.

maybe parting out ...or $2005obo Thanks dave...

do you have a dyno sheet you could post? id like to see where the power is



and how would this be for a dd? is the mileage bearable?

I was told when I bought it it had between 10-15k and I put 4500k on it...The oil seals are geting to the point were oil is added at about 1/4 quart every 120miles..I have a dyno sheet of the older twin weber dcd's ,I don't know how to post it here but if you e-mail me dlesky@cfl.rr.com Icould send them to you...The carb is alone $1000 so if you part it out it is a good deal....

Price brake down

gene berg 58mm ida $950

racingbeat intake ported by kilo racing $350

scatter sheild $150

short shifter $150

lightweight flywheel $250

moroso aluminum oil pan $300

dual coils $40

carter street strip pump $40

fram gas filter $40

holley fuel pressure reg. $30

racingbeat wires$40

new 4 puck disc. $50

act pressure plate$ 200

trans just gone threw and shifting good.....

I bought the motor for $2500 and changed the intake and got it tuned by Kilo racing...It runs strong and I'm sure it put 225plus to the ground ,it needs seals and i'm going turbo so I don't want to put any more into this set up....I'm sure it would go 12's with a lighter car....Thanks Dave...

nm since it needs seals, it is a good deal though