13B 4-port engine, mostly new components
13B 4-port engine w/FB front cover
Engine came out of school car so didn't get run much, less than 100hrs run time. 13GSL-SE rotors e-shaft Receipt from Mazdatrix for all but the rotor housings & apex/corner seals New irons (S5 TII, improved castings over S4) New rotor housings (FD) New seals & springs (Stock 2mm, w/FD corner seal springs) New corner seal rubber New gears & bearings New tension bolts w/seals New oil pump/chain Racing Beat racing pressure regulator New CAS, wires cut (used to have weatherpack to ECM) Mazdatrix 4" underdrive pulley Mazdatrix oil pan baffle Ports mildly massaged Surface finish extremely smooth, inside of port slightly rougher Bowl volume increased & runners shaped as close to constant area as possible Opening beveled and opened slightly (~1*) sooner Closing blended closing slightly (~0.5*) later Outer edge taken to 2mm from corner seal track Inner edge taken to 1mm from oil scraper track Fully blueprinted with build book of measurements/clearances. All hard parts measured and confirmed good by FSM standard. Engine is loose and out of car so I can't take compression readings but was running strong when removed from the car and lubed for storage. (Has been sitting approximatly 6 months) Comes with Mazdatrix aluminum NA flywheel w/new friction surface & hardware. Mazdatrix heavy duty clutch/PP. Need $2000, picked up. Could deliver or meet within 2hr from Columbus, Indiana for the cost of fuel. https://lh5.googleusercontent.com/-H...-01-44_717.jpg https://lh3.googleusercontent.com/-C...-02-33_443.jpg https://lh6.googleusercontent.com/-r...-01-58_261.jpg https://lh5.googleusercontent.com/-M...-05-33_599.jpg https://lh3.googleusercontent.com/-P...-04-46_589.jpg Yeah, by smooth I mean 2000grit, that took forever... [standard disclaimer] All parts in good working condition unless otherwise stated but are sold as-is and sales are final, so please ask questions if you have them and request photos if you want them. I am more than willing to oblige. I tend to ship within 2 days of clearing payment and I will forward a tracking number to your email when the item is dropped off. [/standard disclaimer] |
Re: 13B 4-port engine, mostly new components
Bump
|
Re: 13B 4-port engine, mostly new components
Would you take $1200?
|
Re: 13B 4-port engine, mostly new components
Im in a hurry man. $1200?
|
Re: 13B 4-port engine, mostly new components
Sorry dude, $1200 is way low balling.
|
All times are GMT -5. The time now is 07:25 PM. |
© 2024 MH Sub I, LLC dba Internet Brands