Ooops?
01-24-2007, 09:35 PM
#5
Senior Member
Thread Starter
Join Date: Oct 2001
Location: Peoria, AZ
Posts: 10,906
Originally Posted by heretic' post='854806' date='Jan 24 2007, 10:25 PM
And yet the housing looks okay.
Apex seal was not broken, and that housing is not gouged. Mikey pointed out maybe it was reassembled like that? Rear rotor was new, housing had a tiny gouge from the last time it blew and was reused. Hmm..
8 psi of boost, .69 P trim On-center To4S, 3" exhaust system 20" long..
Gls-se rotors, compression has got to be past 9, looks like high 9s.
8 heat range spark plugs
and the killer, no IC or w/a injection DOH.
Oh yeah its carbed..
01-24-2007, 11:27 PM
#7
Senior Member
Join Date: May 2002
Location: California
Posts: 22,465
Originally Posted by heretic' post='854816' date='Jan 24 2007, 08:35 PM
The 12A Turbo guys run 9.4 rotors and 12psi boost with no intercooling or water injection, no problems. Just keep your tune on the conservative side.
That's what those GSL-SE rotors are, if unmodified. 9.4:1.
the older ones are 9.2, but not all of em, or hey maybe thats even for the 12a's....
01-25-2007, 12:02 AM
#8
Senior Member
Thread Starter
Join Date: Oct 2001
Location: Peoria, AZ
Posts: 10,906
Well come to think about it, those rotors must have been reused. I took off the downpipe and there is no damage to the exducer. I have yet to examine the inducer where damage usually is; but still I wouldn't think a chunk that big could get by the exducer...
Another hack job out of CA..
A different sandrail stopped by last week, 2 runs and the 8,000 motor blew....
These shops are charging SO much its unreal, and the only thing they know is how to due is make money.
I have to redue everything on this vehicle like all of them.
Another hack job out of CA..
A different sandrail stopped by last week, 2 runs and the 8,000 motor blew....
These shops are charging SO much its unreal, and the only thing they know is how to due is make money.
I have to redue everything on this vehicle like all of them.
01-25-2007, 02:42 PM
#9
Senior Member
Thread Starter
Join Date: Oct 2001
Location: Peoria, AZ
Posts: 10,906
Originally Posted by j9fd3s' post='854800' date='Jan 24 2007, 09:13 PM
wow, air filters!
You were right again,
Found sand in the turbo inlet duct...
Still must be a combo of metal shavings/sand chewing that engine apart.
Well I trashed that whole thing, I noticed the smaller oil pump on that motor, didn't do the job for 8 psi...
01-25-2007, 05:44 PM
#10
Senior Member
Join Date: May 2002
Location: California
Posts: 22,465
Originally Posted by 1Revvin7' post='854887' date='Jan 25 2007, 12:42 PM
You were right again,
Found sand in the turbo inlet duct...
Still must be a combo of metal shavings/sand chewing that engine apart.
Well I trashed that whole thing, I noticed the smaller oil pump on that motor, didn't do the job for 8 psi...
id like to see more pix before i pass judgement, but it sounds like thats an rx4/5 13b from the 70's