or u can just screw a wood screw tight into it and then pull it out with pliers https://www.nopistons.com/forums/pub...DIR#>/wink.png
|
Bah! Thats not complicated enough! https://www.nopistons.com/forums/pub...#>/biggrin.png
|
|
Originally Posted by kahren' date='May 26 2003, 09:00 PM
or u can just screw a wood screw tight into it and then pull it out with pliers https://www.nopistons.com/forums/pub...DIR#>/wink.png
|
I have seen the edge of the water seal break off before.
Wargasm has one att his house where nearly 2 inches broke off. |
The one here has ~ 1" broken off
|
Originally Posted by j9fd3s' date='May 27 2003, 10:51 PM
|
Originally Posted by Judge Ito' date='May 27 2003, 11:22 PM
I see you haven't really tried using a screw. That roll pin will not except anything but a weld. That pin chews up drill bits,screws,center punches,chisles you name it it eats it right up..
i did this on a rotor housing and it worked really well took about 1 minute. |
All times are GMT -5. The time now is 10:41 AM. |
© 2024 MH Sub I, LLC dba Internet Brands