Rotary Engine Building, Porting & Swaps All you could ever want to know about rebuilding and porting your rotary engine! Discussions also on Water, Alcohol, Etc. Injection

Wish To Rebuild...

Old Apr 12, 2005 | 12:33 AM
  #1  
Wankelteer's Avatar
Thread Starter
Member
 
Joined: Feb 2004
Posts: 72
Default

I have an 87 TII. I believe I blew my engine, it made a loud backfire noise in the engine bay when it was under heavy load. The car seemed to run fine untill I turned it off. Then she would start, but shortly die. I did a compression test, and the rear rotor read about 35-35-10. Front was about 35 on all sides(all these numbers are rough, not sure if Im doing the comp test right). Im wondering if the car should idle with these compression numbers? Could I have blown out a side seal? Should I try using that atf trick as a last resort? Any feedback would be appreciated.
Old Apr 12, 2005 | 12:38 AM
  #2  
phinsup's Avatar
Administrator
 
Joined: Jul 2001
Posts: 24,416
From: Stuart, FL
Default

With that low of compression you got issues.
Old Apr 12, 2005 | 01:11 AM
  #3  
chase78's Avatar
Senior Member
 
Joined: Oct 2002
Posts: 296
From: Phoenix, AZ
Default

yea... if you had 90psi on each face you are on the boarderline.but you have30.....

So 30psi = bad engine
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
estrada42
Rotary Engine Building, Porting & Swaps
1
Jan 31, 2007 06:21 AM
Twin89Stangs
Insert BS here
14
Oct 5, 2002 02:38 AM
turbovr6
Insert BS here
7
Sep 3, 2002 10:16 AM
turbovr6
Kills
1
Feb 21, 2002 06:35 PM
T88 Cwestin RX7
Interior, Exterior, Audio Mods
6
Nov 10, 2001 03:19 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Thread Tools
Search this Thread

All times are GMT -5. The time now is 01:18 PM.