i have a spare 13B n/a 6 port that I got with my 88 that has good compression but bad water seals. If I where to use a TII center iron TII rotors and the 6 port endplates with a TII lim that i ported back when i did a N/A turbo, and the n/a rotor housings w/ N/A eshaft will the parts work together?

 

so it would be a t2 motor with 6 port endplates? yes that works fine

 

I think you will need the 6 port lim.

 

Not if its port matched. Bolt pattern is the same.

 

just a recap



N/A rotor Housings -Diffusers

N/A e-shaft

N/A 6 port endplates

TII Center iron

TII Rotors



Is Good To Go?

 

I would say so. Why do you want N/A housings with diffusers? Use TII housings. If it's a sandrail, who cares about noise level? That's all the N/A diffusers are for.



What are you going to use to run it though? I don't know how well that would run on a stock ECU (if that's what you were thinking of using). I don't think it would keep up with the volume of air you'd be moving though that motor.

 

pulled a haltech from a buddy of mines car wreck he had it sitting for over a year gave him $200 bucks for it and it still turned on the motor when removed might use that



the reason i want to use n/a housings is becuase i got a good set lying around ! ! !

 

Cool.



If you can find some junk TII housings, pull the sleeves out and swap them in. Well you don't have to, but..