[attachment=41212:attachment][attachment=41213:attachment][attachment=41214:attachment][attachment=41215:attachment]Whats up to the porting GODS. I got my porting templets from judge ito, my plates where already previosly ported by someone else. Now these are not even close to finish i just want some advice on what to do. On my bottom front plate the radius is much widder then any of my other plates. now im going to put my housings on top and see if i should port more towards the intake opening? and i want this port to run good and strong. so any advice from the porting masters would be awsome. ? (Front plate is the upper left picture Intermediate plate pics are top center and top right, and my rear plate is the bottom left pic)

 

loooking good, I sent you my aggresive streetport, I do not offer the wild streetport template. all you need is to fine tune your radius lines.. not bad work..