[quote name='guitarjunkie28' date='Apr 23 2005, 05:23 AM']no worries if you go through the water jacket--metal epoxy will patch it right up.


[/quote]

Ok, I thought if you went through it would be scrap?

So are you saying its a bit small? https://www.nopistons.com/forums/pub...DIR#>/wink.png

not really. looks like you can make it a bit wider to advance the intake timing, but throw down some lexan or plexiglass to make sure your side seal leading edge will still be supported to avoid potential falure.



overall, it looks good.

That was one of the reasons i painted the plate first and ran the rotor round it with just the Corner seals + springs in. I was after 2/3's of the corner seal track left.



The reason it doesn't look right at the bottom (bit thin) it that i took the (oposite edge to the closing one) down about 4mm which made it look like a stocker again (on a pic) what i should have done is taken a pic before and after sort of thing.



Cheers