made this...turbo is from a ford powerstroke truck. so it had some wierd pedestal that has feed and return on the same side.



turbo is pretty nice. has a 1.10ar front and a 1.15 rear. but theres a factory replacement exhaust housing i picked up for $149 bran spanking new that makes it a .84 rear!!!

 

sorry for the blurry pics. my camera sucks. and i still need a -4AN fitting for the feed. return is a -8

 

wierd good work tho

 

Return has to be a minimum of -12 for a journal bearing turbo. Since you can fabricate yourself you should look into making hardlines instead of using rubber braided hose.

 

-12? damn thats big.



and im planning on using hard lines. thats a hard line -AN fitting. i have a few left over from when i ran -8 hard lines from my fuel cell to the motor. not a fan of the braided anymore.

 

+1