I was thinking about getting a Stage 2 street porting job done. what other mods go alone with street porting, what other mods should be done immediatley after street porting... https://www.nopistons.com/forums/pub...1047683894.gif https://www.nopistons.com/forums/pub...IR#>/boink.gif

a rebuild goes along with it ....

ouchy stage 2 port you'll get the same fuel mileage as a BIG SUV.

you need a full exhaust (headers if na) and then an intake setup (optional)



mike

about how much would a street port and a rebuild cost?

$2000 + housings, rotors, etc if yours are bad generally speaking https://www.nopistons.com/forums/pub...DIR#>/wink.png

how much if i buy an a-spec engine and street port it

its the same price. rebuilding doesn't cost that much as long as rotor housings, side housings, rotors, all that stuff is still reusable. its when you blowup an engine that rebuilding gets expensive!!! mine cost $5000 but everything is new except eshaft and rotors!

so i should only stage 1 street port it???

https://www.nopistons.com/forums/pub...IR#>/boink.gif https://www.nopistons.com/forums/pub...#>/BURNOUT.gif