Rotor apex slot ISSUE! 23/8/15
hi fellas
i have cooked my 13b . all the internals are in good condition besides the slots for the apex seals have closed up on the front rotor just in the corners i have filed them back to normal to have a .04mm clearance but what is to say they wont do it again and loose compression . can somebody please explain what has caused this because the rear rotor is fine. also who else has fun pulling down a block with dowels without damaging anything, i soaked it for weeks but it was like the through bolts were machined too tight can i machine them down a little and still have a strong engine. thanks |
Re: Rotor apex slot ISSUE! 23/8/15
anybody?
|
Re: Rotor apex slot ISSUE! 23/8/15
if you overheated the engine really bad, then it could simply have been pinched from the housing warping or trying to warp (but the dowels interfered).
|
All times are GMT -5. The time now is 11:24 PM. |
© 2024 MH Sub I, LLC dba Internet Brands