Pics From My Rebuild, *finally*
#1
As continued from this thread:
http://www.rx7club.com/forum/showthread.ph...threadid=260332
and ultimately these threads:
http://www.rx7club.com/forum/showthread.ph...threadid=260953
I've decied to build my own motor, and I just got some of my internals back from rick engman
i'll link all pictures as they're HUGE
budget
http://www.1131.net/pics/brian/DSCN1212.JPG
just picked up the engine from mazmart
http://www.1131.net/pics/brian/DSCN1238.JPG
all tools aquired
http://www.1131.net/pics/brian/DSCN1233.JPG
eccentric shaft was worn
http://www.1131.net/pics/brian/DSCN1210.JPG
after micropolishing
http://www.1131.net/pics/brian/DSCN1242.JPG
all bolts/front cover components polished
http://www.1131.net/pics/brian/DSCN1240.JPG
prepping the rotors and clearancing side seals
http://www.1131.net/pics/brian/DSCN1249.JPG
rotors assembled and side seals clearanced, new bearings installed, 2mm solid corner seals, rotary aviation 2mm apex seals (not shown)
http://www.1131.net/pics/brian/DSCN1250.JPG
right now gotham racing's steve kan is porting the plates, when i receive his permission and some final pictures, i will be posting those as well....
stay tuned for some pics of the powdercoated engine
http://www.rx7club.com/forum/showthread.ph...threadid=260332
and ultimately these threads:
http://www.rx7club.com/forum/showthread.ph...threadid=260953
I've decied to build my own motor, and I just got some of my internals back from rick engman
i'll link all pictures as they're HUGE
budget
http://www.1131.net/pics/brian/DSCN1212.JPG
just picked up the engine from mazmart
http://www.1131.net/pics/brian/DSCN1238.JPG
all tools aquired
http://www.1131.net/pics/brian/DSCN1233.JPG
eccentric shaft was worn
http://www.1131.net/pics/brian/DSCN1210.JPG
after micropolishing
http://www.1131.net/pics/brian/DSCN1242.JPG
all bolts/front cover components polished
http://www.1131.net/pics/brian/DSCN1240.JPG
prepping the rotors and clearancing side seals
http://www.1131.net/pics/brian/DSCN1249.JPG
rotors assembled and side seals clearanced, new bearings installed, 2mm solid corner seals, rotary aviation 2mm apex seals (not shown)
http://www.1131.net/pics/brian/DSCN1250.JPG
right now gotham racing's steve kan is porting the plates, when i receive his permission and some final pictures, i will be posting those as well....
stay tuned for some pics of the powdercoated engine
#9
yeah, i don't think anyone else has tried the twins on this setup, many have argued...but few have tried
the irons are probably going to be lapped when i get them back, those "oopsies" are from sandpaper, not a high speed tool
the irons are probably going to be lapped when i get them back, those "oopsies" are from sandpaper, not a high speed tool