Peripheral Port Renesis?
#1
Is the side port exhaust really all that much better than the older peripheral exhaust port?
What I'm wondering is if you took Renesis irons and blocked off the intake ports and got the Renesis rotor housings machined for a Peripheral Port.
Would the port timing on the Renesis irons for the exhaust be any good for a PP N/A application? I haven't yet had the opportunity to tear down a Renesis motor yet, so any Renesis experts can hopefully answer my question
Thanks
What I'm wondering is if you took Renesis irons and blocked off the intake ports and got the Renesis rotor housings machined for a Peripheral Port.
Would the port timing on the Renesis irons for the exhaust be any good for a PP N/A application? I haven't yet had the opportunity to tear down a Renesis motor yet, so any Renesis experts can hopefully answer my question
Thanks
#3
I've looked at peripheral inlet & exhaust porting a renesis housing and came to the conclusion it would be a huge amount of work, only beacuse the ex side would be difficult to do. The advantage is the ex opening could be made later like the MFR housings.
Edit- whoops, read the question wrong.
Edit- whoops, read the question wrong.
Thread
Thread Starter
Forum
Replies
Last Post
Hyper4mance2k
Rotary Engine Building, Porting & Swaps
8
02-11-2009 11:37 PM
Chaotic_FC
Rotary Engine Building, Porting & Swaps
11
02-05-2009 12:01 PM
evolutioned_rx7
Rotary Engine Building, Porting & Swaps
5
10-20-2003 10:45 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)