my o rings need to be replaced. I'd like to port my 6 port when it's apart . I've seen some ok pictures of ported 6 port housings but not enough detail . Does anyone have templates or measured drawings. If not can you see the water passages or do you just need to know where they are. I know this comes up alot but I realy couldn't find a good answer.

thanks Dave

 

unless u have, full exhaust and intake manifolds there is really no point to street port it.



i will have some templates made soon for the 6 port engine

 

I'm willing to get a stand alone and modify the intake to make the port job realy work. I just don't want to spend alot of money on a rebuild right now. I like the looks of the Judge Ito port job but I don't want to trash my housings trying to get there. I have never taken a rotary apart is it obvious where the water passages are before you cut into them? how much material should you leave between the water passage and the port? I want hp this car will never see the street .

thanks

Dave