Mounting Stuff On To Block?
#1
The manual is 2 dimensional and the atkins video is not enough detail.
I'm at the stage to mount the rats nest. I couldn't figure out the exact position of the oil pipes, so I just tried to match with the picture in the manual. I'm using SS braided oil metering lines, so those and the hard lines make mounting the rats nest a PIA.
Does anyone have any pictures or some help they can give me? I'm just a computer geek, where does the floppy go?
I'm at the stage to mount the rats nest. I couldn't figure out the exact position of the oil pipes, so I just tried to match with the picture in the manual. I'm using SS braided oil metering lines, so those and the hard lines make mounting the rats nest a PIA.
Does anyone have any pictures or some help they can give me? I'm just a computer geek, where does the floppy go?
#3
I think they're the hard oil lines to the stock twins. The manual says it goes on before the rats nest bu then it seems like it would take some pressure to screw down the rats nest on top of it. I just don't want to put it together wrong and then have to get to it after the engine is back in the bay.
#4
OK, it's called the turbo oil feed line on the Atkins video. The problem i'm having is the angle of the banjo hole where the bolt goes through to attach it to the block is not flush. Can I rotate the banjo fitting?
Thread
Thread Starter
Forum
Replies
Last Post
Xynic
RX-7 & RX-8 Parts For Sale & Wanted
2
12-16-2007 04:44 PM
KompressorLOgic
Northwest Regional For Sale Forum
20
01-31-2007 07:09 PM
Stock Josh
RX-7 & RX-8 Parts For Sale & Wanted
2
11-26-2006 05:39 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)