|
Looking around Mazdatrix and I found these. I will be getting em soon for my build. http://www.mazdatrix.com/studkit.htm
http://www.mazdatrix.com/pictures/b-engprt/stud.jpg |
Nice
I wonder if the torque value should be changed.. |
looks like the extremerotaries kit
|
they do not have the ribbed OEM tension section in the middle... As far as I remember those were an upgrade within Mazda itself as well.
|
Damn looks like you will finally be able to put 13B rotors in a 12Amotor https://www.nopistons.com/forums/pub...#>/biggrin.png
|
looks like it'd be a bitch to tilt the center plate when you put the engine together.
|
Originally Posted by ColinRX7' post='789401' date='Dec 22 2005, 09:49 PM
Nice
I wonder if the torque value should be changed.. The High Strength Oversized stud kit eliminates the need for doweling the engine block. All studs act as dowels which massively increases torsionial strength 70%. Rotor housing deflection reduced - increases apex seal life. Less material machined from housings and plates than with doweling, reducing the possibility of cracking. High boost engine expansion reduced. Studs are less prone to stretching under high boost applications. More accurate tensioning of engine. Less chance of bolt breakage. High quality 12-point nuts rated at 180,000 PSI tensile strength. Studs manufactured from 4140 chrome moly, heat treated, centreless ground and black oxided. Engine must be accurately drilled reamed & tapped to give 0.2mm clearance. Note the standard factory manual flywheel cannot be used with the Stud Kit. |
Does anyone know if there is a kit like this for the 20B ?
|
Originally Posted by GreyGT-C' post='789508' date='Dec 23 2005, 08:23 AM
looks like it'd be a bitch to tilt the center plate when you put the engine together. Should be the same as any other engine build. The studs probably get installed last, or at least after the center housing is laid on. |
Originally Posted by heretic' post='789586' date='Dec 23 2005, 03:42 PM
Should be the same as any other engine build. The studs probably get installed last, or at least after the center housing is laid on. Correct. You install them after you got the center housing on. They can be a bitch to get in the first time https://www.nopistons.com/forums/pub...DIR#>/wink.png |
| All times are GMT -5. The time now is 01:28 AM. |
© 2024 MH Sub I, LLC dba Internet Brands