Gsl-se Rotors Housings In A S4,s5,s6 Engines
08-22-2005, 08:08 AM
#1
Senior Member
Thread Starter
Join Date: Oct 2002
Location: Phoenix, AZ
Posts: 296
Do GSL-SE have a groove in the AL rotor housings like the 12a do for the water jackets.
Do the gsl-se have the same number of bolts and bolt patterns as the later 13b?
can i use gsl-se in s4,s5,s6 ?
Do the gsl-se have the same number of bolts and bolt patterns as the later 13b?
can i use gsl-se in s4,s5,s6 ?
08-22-2005, 08:49 PM
#4
Senior Member
Join Date: Jun 2004
Posts: 524
Aren't there some 12A racers using FD end housings for their dowel pin strength?
I often wonder if filling the coolant passages in jacket-cracked FC side housing would make them useable in an early engine. Probably not, insufficient support and all, but it is something fun to think about while hauling a load of junk housings to the recycler's. It's always difficult to throw stuff like that away.
I often wonder if filling the coolant passages in jacket-cracked FC side housing would make them useable in an early engine. Probably not, insufficient support and all, but it is something fun to think about while hauling a load of junk housings to the recycler's. It's always difficult to throw stuff like that away.
Thread
Thread Starter
Forum
Replies
Last Post
Bastard
Rotary Engine Building, Porting & Swaps
21
09-01-2008 12:19 AM
RX7 13B 4 UR AZZ
RX-7 & RX-8 Parts For Sale & Wanted
1
09-22-2007 08:40 PM
mike_rudy
RX-7 & RX-8 Parts For Sale & Wanted
1
12-15-2006 09:08 PM
RotaryRocket219
RX-7 & RX-8 Parts For Sale & Wanted
0
01-08-2003 07:27 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)