13bre intake manifold to 13brew, porting advice needed
Thread Starter
Junior Member
Joined: Jan 2012
Posts: 2
13bre intake manifold to 13brew, porting advice needed
i am building a 13brew and the intake (LIM & UIM) will be 13bre. i know this has been done before and did some searching but didn't score.
the bre intake gasket has a lower floor to the FD port by quite a margin.
is there enough meat on the FD floor to match the gasket?
what is the proper way to do the job... this will be a 500+ hp build.
thanks,
Howard
the bre intake gasket has a lower floor to the FD port by quite a margin.
is there enough meat on the FD floor to match the gasket?
what is the proper way to do the job... this will be a 500+ hp build.
thanks,
Howard
Thread
Thread Starter
Forum
Replies
Last Post
howard coleman
Rotary Engine Building, Porting & Swaps
1
Apr 13, 2014 09:35 AM
rmphillip
Rotary Engine Building, Porting & Swaps
11
May 8, 2003 04:06 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
