Closer ..

 

what kind of cam did you end up with? those pics look pretty good...

 

Thats Rikkis Sony cybershot DSC-S50

 

Hey check it .. My rotors cleaned up great. I soaked them overnight in a Simple Green/Laquer thinner bath.. :bigok:

 

Here is the entire engine ladies..

 

I had to post this pic it came out so good.





I would hate to look at this thread on dial up.. :smirk:

 

My intake porting See the most recent work on that link.. :bigok:

 

Ok well I haven't been keeping up this thread. I finished all the porting. I have the housings all cleaned up and ready to go also.

I picked up a few of the parts I need, but there is alot left.

I grabbed a new Walbrow off ebay the other day. I also just picked up the new apex seals & springs from Malloy.

I am spacing out the purchases so I don't break myself. It would be easy to do.



I also bought an engine stand from harborfrieght.com for about $50.



I fucked up Rikkis camera or I would have pics. I'll get some pics up in a day or two.

 

Aight I got the plate mounted on the engine stand I'm just waiting to pick up my gears and rotors tomorrow form Peters.

I was getting new bearings pressed in.I am picking up my midpipe with the borla also. Other than that I need to buy a few seals and o-rings.

Maybe another $200 or so. I got the fuel pump in yesterday. I also bought a Tripoint 8.5 lpd. flywheel.That should be here soon.

So I am still short a clutch and radiator. Other than that it is gonna be just little odds and ends like the IC pipes, etc.

I'll be back..

 

Sweet! Good work man! I feel like pulling my motor again too! LOL!