NoPistons -Mazda Rx7 & Rx8 Rotary Forum

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)
-   Meet and Greet (https://www.nopistons.com/meet-greet-79/)
-   -   New to the rotary! (https://www.nopistons.com/meet-greet-79/new-rotary-71969/)

FBRAPPIN 03-24-2009 09:58 PM
What's up guys,

My name is Nick, I am new to this forum and new to the rotary engine. I have been introduced to the rotary engine from my friends, so I am deciding to get a FB to start with. I am planning not planning on getting a GSL-SE because i want it carbeurated and simple at first. I know they are good little snappy motors that can with stand a bit of beating. I have owned nothing but imports, and look forward to working with this beast. My plans are keeping it a street car, and doing all the work myself and learning all about the motor. I have down quite a bit of research on the topic, and found myself doing a mild street port, getting a holley carb, MSD ignition system (ngk plugs), 6psi fuel pump, racing beat header and full 2.5 inch piping. then getting a T2 tranny. i think i know most of the things i wanna do. its just i need time and money, and tons of research.

Thanks guys looking forward to answering question and asking them too!

RotorDad 03-25-2009 06:13 AM
Originally Posted by FBRAPPIN' post='919041' date='Mar 24 2009, 10:58 PM
What's up guys,

My name is Nick, I am new to this forum and new to the rotary engine. I have been introduced to the rotary engine from my friends, so I am deciding to get a FB to start with. I am planning not planning on getting a GSL-SE because i want it carbeurated and simple at first. I know they are good little snappy motors that can with stand a bit of beating. I have owned nothing but imports, and look forward to working with this beast. My plans are keeping it a street car, and doing all the work myself and learning all about the motor. I have down quite a bit of research on the topic, and found myself doing a mild street port, getting a holley carb, MSD ignition system (ngk plugs), 6psi fuel pump, racing beat header and full 2.5 inch piping. then getting a T2 tranny. i think i know most of the things i wanna do. its just i need time and money, and tons of research.

Thanks guys looking forward to answering question and asking them too!
welcome to the site

ecko 03-25-2009 08:30 AM
welcome im new to the forum too but not to the rotary hope you enjoy it.

Baldy 03-25-2009 03:16 PM
Welcome to nopistons!


All times are GMT -5. The time now is 05:08 PM.


© 2024 MH Sub I, LLC dba Internet Brands