krylon fusion paint



scratch resistant and "bonds" to plastic

don't do this :(



had to redue b/c of the bondo/plastic hardness



It would also crack along seams when presure was applied.



weld the plastics together with a solder'n iron.



and don't have a straight edge somewhere. Use the iron to make it curvy.

another pic

why don't you just use fibreglass? Other then that, it looks great

why does seemingly everyone relocate their controls?

fiber glass won't fill in the large holes as well.



fiber glass is usually used for structural integrity but by melting the plastics it provided enough so i only needed filler and bondo is alot better at that.

the reason i relocated the controls is so i can put my electronic boost guage/controller in a visible spot so it will be easy to see when it warns.

i need to get instructions on this mod anyone who has a full proof way of doing this mod please post!!!!!!

there is no such thing as a full prof mod. Just like a fool proof plan.



take advice from what other ppl have said and just man up and dig in https://www.nopistons.com/forums/pub...IR



prepare for alot of down time if you want it really good.



it's not that hard just time consuming.



i'm really broke so doing my interior and letting my engine sit in about 100 pieces sounds like my best plan https://www.nopistons.com/forums/pub...IR#>/smile.png

Did you shoot clear on any of the pieces? They look good but it looks like the final cut and buff was left out.