How To Tap?
#12
i was fooled too:
Originally Posted by Sinful7' date='Feb 7 2005, 05:15 PM
#14
the oil also helps clear chips out of the tap. if you are tapping on a cnc machine, or an upright drill or something where the machine does the cutting, if you have to pull it out, remember to start the tap by hand before continuing on with the machine.
oil!
oil!
#15
Originally Posted by Rob x-7' date='Feb 7 2005, 06:24 PM
its only a shift ****, its pretty hard to mess up, put it in a vice with some rubber jaws, dont go nuts on the vice, just snug it up, the **** should already be drilled so all you are doing is making a larger hole, then tap by hand, check it on the car to see when the engraving lines up, if you got no engraving then its even easier.
In the mean time I made it so my headlight could close without hitting anything, hooked up the connector arm and plugged it in. ahhh, having 2 headlights is so nice!
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)