1983MazdaRx7_JM |
03-14-2009 02:33 PM |
Hey guys! i have a 1983 mazda rx7 that i just bought. the car has some engine problems and wont start. I was told by the previous owner that it needed a Slave Cylinder, however, I can still turn the engine and crank it (it just wont turn over and start) and the clutch does disengage and pops into gear. I tried jumping it (because the battery was dying) and also sprayed starter fluid in the carb and neither helped. I also noticed that the exhaust is missing a center section, do you think that this might be an issue because of lack of compression? any helpful insight is greatly appreciated. thanks in advance.
Joe
|