Quick Question When Installing E6x...
04-28-2005, 06:46 AM
#1
Senior Member
Thread Starter
Join Date: Jan 2005
Location: Albuquerque, NM
Posts: 163
When installing a standalone in the TurboII, what do you do to hook the coolant sensor back up thats on the driver side of the motor to the guage in the dash? The wire was originally in the ECU harness.
04-28-2005, 11:26 AM
#2
Senior Member
Join Date: Nov 2001
Location: LA, USA
Posts: 1,622
[quote name='RE87FC' date='Apr 28 2005, 04:46 AM']When installing a standalone in the TurboII, what do you do to hook the coolant sensor back up thats on the driver side of the motor to the guage in the dash? The wire was originally in the ECU harness.
[/quote]
In the old ecu harness there should be a connector that hooks up to the dash board. There is one wire. usually yellow, thats' the coolant. Run a while from the sensor to that wire. I used the the old plug so it looks all stock. This plug also has the power to the wiper motor and cruse control. You need to get the schematic so you can find it with no problem.
[snapback]705598[/snapback]
[/quote]
In the old ecu harness there should be a connector that hooks up to the dash board. There is one wire. usually yellow, thats' the coolant. Run a while from the sensor to that wire. I used the the old plug so it looks all stock. This plug also has the power to the wiper motor and cruse control. You need to get the schematic so you can find it with no problem.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)