Power Fc For Fc3s
#31
Originally Posted by Turbo II FC' date='Dec 24 2003, 11:45 PM
Since I started this topic and it arose from the dead, i thought I might give an update. I acquired a Power FC for my FC from Jap Parts Specialist. I highly recommend him to anyone. If you are looking into getting a Power FC for your FC then you should try to get one through him since he comes across these often. His site is http://jappartsspecialist.com/
#32
I havent installed it yet since ive been so busy out of town here and there and I recieved it not too long ago but its definately on my to do list when I get back to home. The Power FC for the FC3S comes with a conversion harness that you can add a 3 bar map sensor and it will eliminate the afm. It comes with a extra wire on the harness that needs to be hooked up to allow the map sensor otherwise you can use the stock afm. I acquired mine for 1250 shipped with insurance through Japan EMS. Thats Power FC, Commander, and harness.
#33
Originally Posted by Turbo II FC' date='Dec 25 2003, 05:12 PM
I havent installed it yet since ive been so busy out of town here and there and I recieved it not too long ago but its definately on my to do list when I get back to home. The Power FC for the FC3S comes with a conversion harness that you can add a 3 bar map sensor and it will eliminate the afm. It comes with a extra wire on the harness that needs to be hooked up to allow the map sensor otherwise you can use the stock afm. I acquired mine for 1250 shipped with insurance through Japan EMS. Thats Power FC, Commander, and harness.
#34
Originally Posted by IGY' date='Dec 11 2003, 02:19 AM
Vosko is correct. You need a $300 to buy you a datalogit, you can steal a laptop from a friend and you are set. I once looked at a supposed bridge port map for an FC with a powerfc with my datalogit and that **** was stock except that the whole correction map was jacked as high as it could go in boost. It was crazy. The guy said it was close to being tuned so I zeroed out his correction map for him to give room to tweak. The guy had paid $300 for nothing basically. Actually he paid $300 for someone to try to blow his motor.
#35
Originally Posted by vosko' date='Dec 29 2003, 09:53 PM
what about the other stuff you need................
Thread
Thread Starter
Forum
Replies
Last Post
k_flip1
RX-7 & RX-8 Parts For Sale & Wanted
3
01-15-2005 04:50 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)