Who Here Has Relocated Coils?
#3
Originally Posted by 9BASE3' date='Jun 3 2004, 12:09 PM
Few questions..
Where do you put them?
What do you do for wires?
Do you need to add any grounds?
Where do you put them?
What do you do for wires?
Do you need to add any grounds?
The lead coil is a 4 terminal device - each end of the secondary coil goes to a separate spark plug wire;
There do exist "isolated ground" coils, such as many COP coils - these require a separate ground wire.
You can put them virtually anywhere you want - just keep them away from the exhaust. Primary wire should be maybe 16 wg. For spark plug wire, just use a good quality suppression wire, and try to route them away from sensitive things like the crank angle sensor and its wires.
#5
Are u still using the power steering and ac compressor? If not i can send u a picture of my setup. It's very simple setup. I still use the brackets where the coil sits in and all u need is 2 spark plug wires from a turbo II. PM me an email address and i'll send u a picture. Later!
#6
Van,
Thanks for the pic! I still have cruize though LOL! Haven't talked myself into removing it yet..
r-magic,
No PS or AC. jdhuegel1@aol.com Thanks!
tampaFD,
Yup. See it. Thanks!
83turbo,
Appreciate it!
Did I forget anyone?
Thanks for the pic! I still have cruize though LOL! Haven't talked myself into removing it yet..
r-magic,
No PS or AC. jdhuegel1@aol.com Thanks!
tampaFD,
Yup. See it. Thanks!
83turbo,
Appreciate it!
Did I forget anyone?
#8
Originally Posted by tampaFD' date='Jun 5 2004, 12:52 PM
someone spot van a zip-tie so his fuse box will stop floping around in there!
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)