Well, She Didn't Start...
02-22-2004, 01:42 PM
#43
Senior Member
Thread Starter
Join Date: Feb 2002
Location: Frederick MD
Posts: 6,331
Originally Posted by 93 R1' date='Feb 22 2004, 01:09 PM
The rubber lines in that pic are the ones that split? Did you use reinforced fuel injection hose.
I pulled the plug and had Zach turn it over... No fuel spraying out..
NOTHING has changed on the primary side.. They are stock, and the harness is untouched on the primaries as well.. Where should I look?
02-22-2004, 02:16 PM
#45
Senior Member
Join Date: Dec 2002
Location: fredneck MD
Posts: 4,107
I'm trying to think what would cause that. The only thing i can think of is that your injectors are bad.
Humm, you have your PFC set for non seq. turbo control right? I would put the secondary injector settings back to stock. That might be confusing it, because you haev to change more then just the size of the injector.
Just drive like a grandma before you get it tunned!
Humm, you have your PFC set for non seq. turbo control right? I would put the secondary injector settings back to stock. That might be confusing it, because you haev to change more then just the size of the injector.
Just drive like a grandma before you get it tunned!
02-22-2004, 02:47 PM
#49
Senior Member
Thread Starter
Join Date: Feb 2002
Location: Frederick MD
Posts: 6,331
Originally Posted by rfreeman27' date='Feb 22 2004, 02:16 PM
I'm trying to think what would cause that. The only thing i can think of is that your injectors are bad.
Humm, you have your PFC set for non seq. turbo control right? I would put the secondary injector settings back to stock. That might be confusing it, because you haev to change more then just the size of the injector.
Just drive like a grandma before you get it tunned!
Humm, you have your PFC set for non seq. turbo control right? I would put the secondary injector settings back to stock. That might be confusing it, because you haev to change more then just the size of the injector.
Just drive like a grandma before you get it tunned!
All I know is that with a test light and the key on... The harness has power all the way to the injector. Just the injector aint doin shiiat..
What controls the primaries? Do the Crank Angle sensors have anything to do with it?
I can't imagine the injectors are bad... Then again my luck sucks.
I just wanna make sure it's not something stupid before I yank the injectors and flush them down the fuggin toilet..
02-22-2004, 04:15 PM
#50
Senior Member
Thread Starter
Join Date: Feb 2002
Location: Frederick MD
Posts: 6,331
Originally Posted by FikseRxSeven' date='Feb 22 2004, 02:18 PM
check if the injectors are getting power
There is power there though.. The test light shows that.. It fired RIGHT up with the fuel from when we opened the injector with a 9V battery.
Is there ANYTHING related in the harness wiring? Like any of the solenoids I cut off? I KNOW no wires are touching..
Are the black/yellow wires the power for the injectors? Or are the colored wires?