1 Attachment(s)
These two hoses don't seem to fit on one side at all, if I use 4mm--but they seem loose on the other side, with 6mm.
|
1 Attachment(s)
General engine location of the hoses, in non-closeup.
|
Is that the line that runs to the vaccum chamber? Make the 4mm fit, better to be to tight then to loose..
|
Unless it's so tight the hose splits after a couple days--that is silicone's achilles heel, right?
|
Before I went single I did my vaccum lines and I didn't have any problems. It should give enough to fit over it. Zip tie it and call it good, just keep an eye on it.
|
3.5 mm should fit. That's what came with the silicon hose techniques set for the solenoids.
|
I just did this job two days ago. I used 3.5mm from Hose Techniques. Good Stuff. Fit like a charm too!!
|
hey i figured it out tonight man...
|
All times are GMT -5. The time now is 01:15 AM. |
© 2024 MH Sub I, LLC dba Internet Brands