Danno

I have had other posts on this but i want to satr at fresh one now.



Heres are the problems:



1- rough idle



2- muffled exhaust



3- just replaced fuel lines before problem started( Had a fuel leak)



4- Oil in intake piping, air filter. This oil is much more than just blow by. The BOV has been blowing oil out.



5- Car shakes ALOT! when running



I did a compression test witha gauge that goes up to 300 psi and it read 90psi on that gauge from both lead plug holes.



thanks for the help guys.

Danno

Maybe I didn't do the compression check right??

fritzfry

when you say 90 is that seeing the needle bounce up and down to 90? my manual says a minimum of 100 psi at 250 rpm is spec but i'm not sure if 90 is good, still ok, or bad. (at least it wasn't zero like i'm getting on my rear rotor )



are you getting smoke? if you've had this post before then i'm sure you already checked the map...that was something suggested to me.



good luck bro



fritz

Danno

What do you mean by checking the map? I am gonna redo my compression test to see whats up.

Dumbrotorkid

make sure that the map sensor didnt come off. mine has come off before and it feels like all hell broke loose. exhaust smokes real bad idle.

Fd3BOOST

The oil is most likely a seconday problem. My guess is that your turbos oil seals are shot.



As far as the rest I think rotorkid has it. Check the map sensor vacum line. It is located on the firewall right above the fuel lines that you say you just replaced so it would make sense that you might of cracked the line or knocked it off.







Cheers