swapping motors...
#1
im swapping my 93 motor out (broken) from a 93-96 JDM front clip motor. any tips or hints to make this go smoother?
would it be best to use the JDM ECU or are they the same?
thanks in adavnce...
would it be best to use the JDM ECU or are they the same?
thanks in adavnce...
#2
Originally Posted by sen2two' post='829406' date='Jul 21 2006, 02:55 AM
im swapping my 93 motor out (broken) from a 93-96 JDM front clip motor. any tips or hints to make this go smoother?
would it be best to use the JDM ECU or are they the same?
thanks in adavnce...
Disconnect from ECU and pull the engine out with the harness and tranny.
Its easier to assemble back this way and put it back in. Good luck!
#3
try to do the non sequential while you have the motor out.... it will be a little more work when the motor is out, but it will make trouble shooting a lot simpler while you're installing and when you have it in
Thread
Thread Starter
Forum
Replies
Last Post
projectsidewaysrx7
RX-7 & RX-8 Parts For Sale & Wanted
2
01-16-2007 05:23 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)