Replacing Differential Question
#11
Okay I got the differential, 2 new bearings and 2 gaskets for each side where the drive shaft attaches. So all i have to do is unbolt the rear housing and the bearing cap and the diff should plop right out? Then i have to get the new bearings pressed onto the new differential and swap the shims from the old diff to the new one. Is that all I have to do? The shims are what sets the pre-load correct? I'm assuming there is no need to change the shims if I'm just replacing the differential and nothing else.
Thanks
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)