NoPistons -Mazda Rx7 & Rx8 Rotary Forum

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)
-   3rd Generation Specific (https://www.nopistons.com/3rd-generation-specific-18/)
-   -   Quick Question (https://www.nopistons.com/3rd-generation-specific-18/quick-question-21406/)

Danno 07-25-2003 04:40 PM
What is the bolt for on the HKS BOV. What does it adjust when you skrew it in and out?? where should I have it set at??

turbovr6 07-25-2003 04:44 PM
it adjusts how much pressure it takes for the valve to open, there is no specific setting. you can usually just leave it alone and it will work fine

Danno 07-25-2003 04:46 PM
OK sound good. I just wasn't sure if I was suppose to adjust it to a certain point. Thanks alot.

Danno 07-25-2003 04:46 PM
If you skrew it in it takes less preaseure and if you skrew it out i takes more preasure right???

j9fd3s 07-25-2003 05:08 PM
Originally Posted by Danno' date='Jul 25 2003, 01:46 PM
If you skrew it in it takes less preaseure and if you skrew it out i takes more preasure right???
i think it might be the reverse, but i really dont know. if you're really bored mark where its at and play with it

turbovr6 07-25-2003 05:10 PM
I think it is the other way, if you screw it in the spring gets tighter and needs more force to open

jspecracer7 07-25-2003 05:44 PM
Originally Posted by turbovr6' date='Jul 26 2003, 07:10 AM
I think it is the other way, if you screw it in the spring gets tighter and needs more force to open
You are correct!



The HKS works the same as the Greddy TypeR(but I've owned both).



Screw it in makes it harder for the valve to open...letting it out makes it easier.



I normally screw mine in so that 1/2 inch of the bolt is sticking out.

Danno 07-26-2003 05:30 PM
thats about where i have it set now So I will leave it alone. It works fine anyway .


All times are GMT -5. The time now is 05:31 PM.


© 2024 MH Sub I, LLC dba Internet Brands