|
Re: THE QUEST FOR 500
Originally Posted by JBs93FD
(Post 851766)
so i just called my engine builder to get a build sheet , I was under the impressionthat the engine was 700 hp capable and its got every thing there to do it except it doesnt have studs or dowels? i just started noticing a little puff of white smoke on start up . possible coolant seals hurt .
dowel has nothing to do with the water seals. |
Re: THE QUEST FOR 500
The builder was saying that on high boost rotarys the housings start to move around a lot , he said he could visibly see the housings chattering and the dowls worn out . He said if the housings lift it give more of a chance for exhaust gas to destroy the water seals ? I haven't had a rotary apart but I guess I will soon get the plesure of taking one apart
|
Re: THE QUEST FOR 500
Originally Posted by JBs93FD
(Post 851782)
The builder was saying that on high boost rotarys the housings start to move around a lot , he said he could visibly see the housings chattering and the dowls worn out . He said if the housings lift it give more of a chance for exhaust gas to destroy the water seals ? I haven't had a rotary apart but I guess I will soon get the plesure of taking one apart
ehh well you can say but im sure play on the dowel will crack the plate quick specially you having ignition problems |
Re: THE QUEST FOR 500
Problem solved ! I put the bur9eq's in the leading and ngk 6725's in the trailing . The car is crisper than ever and boost comes on 1000 rpm earlier.
|
Re: THE QUEST FOR 500
awesome. get it on the dyno again and see
|
Re: THE QUEST FOR 500
Updates?
|
Re: THE QUEST FOR 500
the plugs were not the cure. shortley after the car started to smoke (burning oil) what i was seeing on the plugs was oil not gas , the front rotor was worse than the rear. during the teardown there was standing oil in the #1 housing and te control ring wearing surface was almost completely shiny on the front rotor, much more than the .020 allowed . so why are they so worn? not replaced during rebuild? side plates too worn (.010 wear at the side seal wear pattern on the combustion side)? e-shaft endplay? oil contol ring clearence? I sent the side plates out to rb to get lapped and ordered a new set of control rings with seals,I plan to reassemble with the fresh housings and control rings also checking all clearences since im a little worried about the builder i chose .
|
Re: THE QUEST FOR 500
2 Attachment(s)
oil ring
|
Re: THE QUEST FOR 500
2 Attachment(s)
rotor #2
|
Re: THE QUEST FOR 500
2 Attachment(s)
side housing
|
| All times are GMT -5. The time now is 10:49 PM. |
© 2024 MH Sub I, LLC dba Internet Brands