i just attempted to install my power fc today and after i did it wouldnt start. turn over but wouldnt start. I followed the directions and cut the two required wires but i got nothing... any help would be great right now!

 

i know it sounds simple but did you disconnect the negative battery cable when you were taking out the ecu and forget to reconnect it?



just a guess, when i put my powerFC in my car ran very well.

 

Hey whats up I am RotaryRevolutions friend and I was the one who put the FC in and there were 4 wires that needed to be cut and I know I cut the right ones because I checked and checked again befor I cut them and I was just wondering if it could have been because we havent installed the downpipe yet but im not sure. And I would also like to know if anyone has had this problem befor. Thanks

 

make sure all the plugs are pushed into the Power FC. That stopped my car from starting a few times...loose connection.

 

i concur

 

Yep this is an easy install.... Plug and pray.. I mean play. check all plugs and make sure your "friend" cut the right wires

 

Start checking everything....fuses, connectors maybe ground wire that runs out of the harrness. Could be alot of different things.

 

ROFLMFAO