which hose to put the T in?

the 4 inch line that goes to the wastegate this is what it looks like and it has a pille in it

nevermind i found it https://www.nopistons.com/forums/pub...IR#>/smile.png

http://www.fd3boost.com/Images/Techn...hosescolor.jpg its a none colored line

I hope you are not joining "Team Home Depot"

Nah Jay I talked him into a turbosmart controller.



Martin run a hose from the turbo pipe, blue line in the pic

https://www.nopistons.com/forums/upl...1057623079.jpg



To the "in" arrow on the controller then connect the "out" arrow on the controller to the wastegate actuator. There should have been a small 5" hose with a wastgate pill in there that you have to remove to put in the new lines.





Very important that you make sure to also remove the 2nd line off the wastegate actuator and cap that end also. Finaly cap the end of the pipe that it was attached to and you should be all set.

Open the controller up about 2 full turns first and you should be able to go from there.

Good Job Dave https://www.nopistons.com/forums/pub...IR#>/bigok.gif

Good Job Dave https://www.nopistons.com/forums/pub...IR#>/bigok.gif [/quote]

Yea the Home Depot **** doesnt cut the mustard.

am i capping the line that goes to the wastegate control solenoid?

nah... hehe, i was actually on my way to buy a blitz sbc id.... but dave saved me the extra 300 bucks..... i got a dual stage turbosmarts boost controller. with the great usd to australian dollar conversion, i only ended up paying 200-something for it.

did you order it from the site??how long did it take to get to you??