Ok basically i need this pipe. I have a pfs intercooler that has the inlet Ic pipe cut. the one that goes from the y-pipe. So, my intercooler looks similar to this one. This also looks perfect because it eliminates the black stock y-pipe pipe.



So, can anyone please tell me where can i get it and how much? I know i've seen it on the couple of the cars, so i think someone must know who makes them and stuff.



Thanks

any decent exhaust shop can make one

really? Well i know i tried a few, and they all told me it's hard to make that 90 degrees bend. When they try to bend it the pipe ends up being 2 inches :(

Yea get an exhaust shop to make you one, or buy the M2 pipe in the pic used from someone.

BTW its replacing the crossover pipe. not the Y pipe pipe. https://www.nopistons.com/forums/pub...DIR

you need to find an exhaust shop that has a "mandrel bending machine" not all shops have them. With that machine you get nice smooth bends that stay the same size throughout

https://www.nopistons.com/forums/pub...1047683785.gif sorry, i know it had a name but i couldn't remember when i was writing https://www.nopistons.com/forums/pub...IR#>/blush.png

We can get pre-made bends at the Green Store (Don't ask)



Then we just get them welded. I'll take you there sometime this week or next if you like. https://www.nopistons.com/forums/pub...IR#>/smile.png

so that pipe is actually m2 pipe? Do they sell it by itself or it only comes with IC?

That pipe comes with the M2 intercooler kit. You MIGHT be able to get it from M2, but I can assure you it'll cost you. AND TAKE FOREVER TO GET... LOL



I'll check the store to see if I can get the 90 bends... https://www.nopistons.com/forums/pub...IR#>/smile.png

https://www.nopistons.com/forums/pub...1047683785.gif sorry, i know it had a name but i couldn't remember when i was writing https://www.nopistons.com/forums/pub...IR#>/blush.png [/quote]

I think im gonna use that one if you dont mind.



Y pipe pipe. https://www.nopistons.com/forums/pub...1047683785.gif