Injector harness ????
#1
IM workin on a 93 and ive been having some probs with ideling REALY RICH and hesitating real bad until 3000 rpm when the sec's kick in then it runs fine i thinck i could have mis pluged the primary injector and there fireing at the wrong time just a stab in the dark.....anyways i was wondering if any one new the correct wire color code for the front and rear primary injectors .....thanks for any feed back...........list of mods are this incase some one else might have a better idea
Street port motor 3mm seals
down pipe
mid pipe
pettit 3'' cat back
hks intakes
m2 ecu/ and stock both having same affect
Street port motor 3mm seals
down pipe
mid pipe
pettit 3'' cat back
hks intakes
m2 ecu/ and stock both having same affect
#3
The injectors do have different color code there is one is......( lt.grn)......one is( lt. grn-blk)....one is( lt.grn-wht)..one is (lt. grn-red) i need to know the primarys colors..................... thanks
#4
Did you try to reset you computer yet...? Most of the time if you unplug the injectors it will cause the computer to freak out.. especially if you turned on your key while they were unplugged... to reset the computer disconnect the - batt teminal and push the brake pedal... then reconnect the batt cable.. see if that cures your problem..
Thread
Thread Starter
Forum
Replies
Last Post
Node
ECU Discussions
19
09-15-2006 11:58 PM
N3philum
RX-7 & RX-8 Parts For Sale & Wanted
0
11-11-2005 10:34 AM
AggieDave
Single Turbo Discussion
2
09-30-2003 06:36 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)