Help Increasing Boost
#1
Ok i am having trouble increasing boost. A few days back some vaccum was off and my car running Non-Seq without any mod... i drove it for a few days boost use to come at around 4500 rpms but from there on it was a wild ride... i was hitting smooth .9 all the time... Now i have a fully functional sequential setup and when the secondary turbo kicks in boost drops to .7 ony.... I tried increasing it from the boost controller. its a greddy E-01..and on the power fc nothing works... the primary turbo its .9 but when the seconadary kicks in it drops to .7
Can it be that i have hooked up the boost controller wrong.... There were no instructions for installation on the rx-7 with the boost controller.. Which actuator do i need to connect the solonoid to..and which one do i have to cap off... Any pictures would help...
Thanks
Can it be that i have hooked up the boost controller wrong.... There were no instructions for installation on the rx-7 with the boost controller.. Which actuator do i need to connect the solonoid to..and which one do i have to cap off... Any pictures would help...
Thanks
#2
I have the following mods on my car.. They were there when the car was non-seq...I did not do the Non-seq mod some vaccum came off and it went non-seq itself..
Apex-i intakes
Apex-i N1 exhuast
Apex-i GT spec radiator
Apex-i Power FC
Knightsports Dual downpipe
Greddy large SMIC
Greddy E-01 Boost Controller
Street Ported Block
Thanks
Apex-i intakes
Apex-i N1 exhuast
Apex-i GT spec radiator
Apex-i Power FC
Knightsports Dual downpipe
Greddy large SMIC
Greddy E-01 Boost Controller
Street Ported Block
Thanks
#4
Do you think all your Vacume lines are hooked up and correct?
I have had the mechanic check and recheck the vaccums. he found them hooked up correct.. I think so too cuz without the boost contoller the boost pattern is ok... Can it be that i have the boost control solonoid connected to the wrong actuator??
Cuz the primary turbo hits around 12 psi of boost...but the secondary drops to 9.5
#5
That could be it. Its gotta be something with the boost controller hook-up if everything runs fine on the regular stock set up. I have had some questions about hooking my Boost controller. I still haven't hooked it up because I don't know where the 3 vac lines go to.
#10
Originally Posted by DeaconFrost' date='Feb 5 2004, 04:42 PM
not without its boost solenoid it doesnt...
I still don't see it...