Ok, I have my exhaust manifold off the car to remove that flapper door inside.....but what did everyone use to cut that door out? I saw the pic of the "cut here" line....but cut here with what...a hacksaw, plasma cutter, torch, etc?



Thanks,

Scott

 

I tried cutting it but then just got the big 4 foot long pry bar on it and it popped right out.

 

2" pnuematic cutting wheel.

 

samurai sword

 

I simply hit it with a hammer and bent it, then took a long screwdriver to it and broke it in half. Took all of 30 seconds to get that damn thing off. Alot easier then I was expecting. Now I just need to go get the hole braised shut. Then start putting it all back together. Then I will again be asking more questions since I can't follow directions very well....so even though your post on full non was awesome Dave....I will more than likely be bugging you about my exact setup.



Scott

 

No worries, just catch me on AIM. RotoGeek7 or IOJINXOI