Stryk3r

Hi guys i know the best place to isnatll and EGT sensor on a 4 cylinder car would be on the manifold on the 4th cylinder side.....but where do i intsall this sensor on the rotary should it be on the down pipe right next to the O2 sensor or somewhere else and what should be the normal running temps?????

FikseRxSeven

the closer to the engine the better...



so if its a turbo motor, right after the turbine

Cheers!

[quote name='FikseRxSeven' date='Jun 23 2005, 06:23 PM']the closer to the engine the better...



so if its a turbo motor, right after the turbine


[/quote]



If you only have 1 EGT should be measured on the rear rotor before the turbo on the turbo manifold.



Ideally you should have two EGT probes measuring the output of the engine at teh ehxuast manifold before teh turbo.

rotarypower101

Any opinions on installing it in the rotor housing itself? I know of a person doing this in each housing to obtain simultaneous readings for a test for a product.