I am pulling motor, everything isremoved but the ecu and motor mounts and do not want to touch until I get some ingo on how to disconnect the stock ecu. Do I just pull the harness through the firewall or are there other ways.

Any advice would help

thanx



93 FD

you can either unplug the harness from the ecu and pull it out of the firewall, or you can uplug everything at the engine and leave the harness in the car

I think the first is easier. Just unplug the ECU, unbolt the little wire elbow thingy, and push/pull the harness through.

Yea and it's nice and easy when you remove the ABS. https://www.nopistons.com/forums/pub...DIR#>/cool.png

Thanks guys for the info.

I had an idea how to do it but wasn't exactly sure.

I guess I will just unplug ecu and pull through firewall.

But wouldn't be a bitch putting back in??? Oh well I will let you guys know how it goes tomorrow.



FD3boost do I completely remove the ABS? https://www.nopistons.com/forums/pub...O_DIR#>/v2.gif

You don't have to. I took off the heat shield and removed a couple bolts, just enough to move it a bit. Definetly easier to pull the wiring harness with the motor.

Once you get the hang of it you can get the harness in and out without moving anything.. Ask me how I know LMAO

I am sorry I was making humor since I have no ABS. If you have abs its no biggie you can still get it out. Its just easier on my car is all.

I thought you were serious LOL

Nice engine bay No ABS I see How do you like it?

Makes engine bay look alot cleaner. https://www.nopistons.com/forums/pub...1047683473.gif

Well finally pulled the wiring harness

It was alot simpler than I thought just had to be really careful.

Next would be to take apart engine https://www.nopistons.com/forums/pub...IR#>/bigok.gif