3rd Generation Specific Talk about 3rd gen RX-7's here.

check engine light

Thread Tools
 
Search this Thread
 
Old Nov 18, 2002 | 04:37 PM
  #1  
grngtcfd3s's Avatar
Thread Starter
Senior Member
 
Joined: Jun 2002
Posts: 272
Default

ok guys i took a drive to san francisco on sat to visit my parants and to go to my brothers house to install my koni's... right before i get onto the 280.... my check engine light comes on... i pulled over to the parking lot and checked my oil.. it looks clean and good. i then check all the wiring and harnesses to make sure nothing was dislocated.... i start the car again and it goes away.. the car drove fine so i just made my 50 mile trip to sf.. now on sunday i'm out going to my friends kid's birthday party... my check engine light goes on again... this time i was at the gas station getting gas... i decided to put a bottle of octane booster just for the hell of it.... this time the light stayed on for 10 mins then want away again.... could this be my o2 sensor... oooo by the way, i put a bottle of fuel injection cleaner last week on my last tank of gas... any ideas????
Old Nov 18, 2002 | 04:56 PM
  #2  
j9fd3s's Avatar
Senior Member
 
Joined: May 2002
Posts: 22,465
From: California
Default

check the codes, i bet you get #16 the egr valve



mike
Old Nov 18, 2002 | 05:05 PM
  #3  
grngtcfd3s's Avatar
Thread Starter
Senior Member
 
Joined: Jun 2002
Posts: 272
Default

it might be.. i had one long flash followed by 6 short fast ones... is that 16???
Old Nov 18, 2002 | 05:18 PM
  #4  
chase78's Avatar
Senior Member
 
Joined: Oct 2002
Posts: 296
From: Phoenix, AZ
Default

16 is EGR. There is two things that ussually works. Buy a new EGR valve $200 or clean out all the sut from the old one for $0. GooD Luck
Old Nov 18, 2002 | 05:24 PM
  #5  
grngtcfd3s's Avatar
Thread Starter
Senior Member
 
Joined: Jun 2002
Posts: 272
Default

how do i clean it out... i'm sorry i'm very new to the FD.. don't know too much about it.
Old Nov 18, 2002 | 05:45 PM
  #6  
j9fd3s's Avatar
Senior Member
 
Joined: May 2002
Posts: 22,465
From: California
Default

you take it off and clean it out with brake cleaner



mike
Old Nov 19, 2002 | 06:17 PM
  #7  
grngtcfd3s's Avatar
Thread Starter
Senior Member
 
Joined: Jun 2002
Posts: 272
Default

ok i'm a idoit.... where is the egr???
Old Dec 22, 2007 | 04:32 PM
  #8  
mrgne's Avatar
Junior Member
 
Joined: Dec 2007
Posts: 1
Default

the EGR is above the turbos on the intake manifold. It'll have a vacuum tube attached to it and if you have a cali version it will have 2 wires connecting to it.



Tip: download the Service manual from www.fd3s.net the egr is under the fuel and emissions section.
Old Dec 24, 2007 | 10:40 PM
  #9  
Sukai94's Avatar
Senior Member
 
Joined: Sep 2006
Posts: 274
From: San Diego
Default

Same thing happened to me last year. I blame California environmentalists and their pointless emission bs



Good luck with it
Old Dec 27, 2007 | 11:23 AM
  #10  
mrb63083's Avatar
Junior Member
 
Joined: Mar 2003
Posts: 8
From: Texas
Default

Like some have already said, the best and for sure way to test it is to get the code.



All times are GMT -5. The time now is 07:51 AM.