Boost Controller Problems
#1
Hey everyone, thanks for reading this. I installed my Apexi BC, and ive done most of the programming steps, but am stuck on what to do for boost/duty and everything else after that. If someone who knows exactly what there doing help please id appreciate it. thanks EEE
#2
ok boost limit and duty cycle are inter-related. Read the manual. it is on apexi-usa.com if you don't have it.
So how to set it up. Set your desired boost level first. Say 0.70 kg/cm^2 and leave the duty cycle blank. Run the car hard and the AVCR will self tune the duty cycle to try to get 0.70 kg/cm^2.
Once you've done a couple of runs you need to fine tune the duty cycle sometimes to get exactly 0.70 kg/cm^2. Sometimes it overshoots a bit, sometimes it doesn't even get close to 0.70
so if it's below 0.70 add like 2% duty cycle and re-run the car. See if it hits 0.70. if it overshoots subtract 2%
You can also change the duty cycle and program a duty cycle curve based on RPM but I'll leave that for a more advnaced lesson.
Good luck.
So how to set it up. Set your desired boost level first. Say 0.70 kg/cm^2 and leave the duty cycle blank. Run the car hard and the AVCR will self tune the duty cycle to try to get 0.70 kg/cm^2.
Once you've done a couple of runs you need to fine tune the duty cycle sometimes to get exactly 0.70 kg/cm^2. Sometimes it overshoots a bit, sometimes it doesn't even get close to 0.70
so if it's below 0.70 add like 2% duty cycle and re-run the car. See if it hits 0.70. if it overshoots subtract 2%
You can also change the duty cycle and program a duty cycle curve based on RPM but I'll leave that for a more advnaced lesson.
Good luck.
#5
i did the self learning step by step as the manual and you said to do it, i hit next when the duty went to astericks, and it never self learned??? the lines in the bar graph are suppose to change and it didnt.? should i just start over and reprogram the whole thing? whats up oh jedi master teacher?
Thread
Thread Starter
Forum
Replies
Last Post
slissek
Performance Mods
0
05-23-2012 07:18 PM
Kouta
Northwest Regional For Sale Forum
3
02-13-2006 06:30 PM
Shaolin Racing
Single Turbo Discussion
7
06-17-2002 11:42 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)