Trailing Problem (cabels Are Cut)
Thread Starter
Junior Member
Joined: Jun 2005
Posts: 5
I have just bought an 83 mod Rx-7 with a 88 TII engine.
The problem is that the "swappers" have just cut the harness to the trailing igniter.
I nead to identify the wires on the ignitor curcuit board with the text (take of the igniter lid c1, tac, cpu1, cI, st, +b, c2) these are not to be found in any wireing diagram in the FSM.
I dont think my trailing coil is working as it should.
Any one that can help me with who is who here (igt, igf ++)
The problem is that the "swappers" have just cut the harness to the trailing igniter.
I nead to identify the wires on the ignitor curcuit board with the text (take of the igniter lid c1, tac, cpu1, cI, st, +b, c2) these are not to be found in any wireing diagram in the FSM.
I dont think my trailing coil is working as it should.
Any one that can help me with who is who here (igt, igf ++)
Senior Member
Joined: Feb 2004
Posts: 363
From: Orange Park FL
The diagnostic procedure is in the fuel & emmissions PDF.
The engine section electrical is at the back.
The trailing coil Info starts on page 5-33.
There is no schematic, but the notes there might help.
The engine section electrical is at the back.
The trailing coil Info starts on page 5-33.
There is no schematic, but the notes there might help.
Thread
Thread Starter
Forum
Replies
Last Post
ccarlisi
Suspension, Wheels, Brakes, Tires
4
Sep 18, 2002 09:48 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
