NoPistons -Mazda Rx7 & Rx8 Rotary Forum

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)
-   2nd Generation Specific (https://www.nopistons.com/2nd-generation-specific-17/)
-   -   Tps Problems (https://www.nopistons.com/2nd-generation-specific-17/tps-problems-24397/)

rotary rebel 09-09-2003 05:27 PM

after i got my new engine installed they told me to bring it back after 5000 miles and they would reset or recalibrate wutever they tps. my car kinda idles funny sometimes from 1.5 to a little under 2.5 rpms sometimes. is that what is wrong and if so where is the tps and how to i tune it. i know where my air adjust screw is but i dont think that has anything to do with it. any help would be greatly appreciated. https://www.nopistons.com/forums/pub...IR#>/blink.png

evilT2 09-09-2003 05:55 PM

woo sounds like mine, cept it never gets much higher than 1.5



ive just been living with it, ive adjusted all the screws and it still does the same thing. kind of obnoxious i guess but not anything to worry about.



if you use the clutch to bring it down to normal idle speed does it stay there?

rotary rebel 09-09-2003 09:57 PM

well it only happens when im stopped and out of gear. it doesnt mess with me when im driving. its allmost like my car is trying to stop it from dying. it starts to drop then revs a little. dunno buddy im confused too.

isamu 09-09-2003 10:57 PM

Look through the faq section, there is a write up on adjusting the tps. It is pretty simple, you just have to make a couple of adjuster lights. However if the place is going to do it for free I would let them. Especially if your engine is under some kind of warranty.

rotary rebel 09-09-2003 11:29 PM

thank you sooo much isamu for posting this and pinning that faq on the tps. i just hope that the spaid is the same thing and the male connector thingy. but none the less good looking out! https://www.nopistons.com/forums/pub...1047683894.gif

rotary rebel 09-09-2003 11:33 PM

and by the way the place that was gonna do this is petes in hampton va. and they left out 2 bolts going from my tranny to my engine block and the rubber plug that is underneath the fywheel in the bellhousing in the tranny so id rather do it on my own. but you the man fer lettin me know. if you ever come around the hampton, newport news area of va let me know i will gladly blaze you up and get you tore with many chicas, it will be a good time!!!! https://www.nopistons.com/forums/pub...IR#>/bigok.gif thanks!


All times are GMT -5. The time now is 09:50 PM.


© 2024 MH Sub I, LLC dba Internet Brands